Detail Hemostatic agents based on ferric sulfate or aluminum chloride – and even the powder in your latex gloves – contain sulfur. Sulfur contamination is one of the primary reasons your impression material won’t set, has voids, or air bubbles. Additionally, organic debris often gets picked up in your impression, causing inaccuracies. These clinical challenges can force you into multiple retakes of the impression. Another common cause of an imperfect impression is uncured methacrylate (from your temporary material) left on the prep site. You may think your air/water syringe cleans the prep site adequately, but it often does not. These kinds of chemical or biological interferences occur more often than any dentist is willing to admit, and unfortunately, the blame is often placed on the impression material when impressions go wrong. DETAIL™ Pre-Impression Cleansing Gel guarantees a clean, decontaminated prep site and consequently, an accurate impression every time. In just 7-10 seconds, DETAIL will lift organic debris and contaminants like sulfur and methacrylate residue from your prep site. Rinse away DETAIL, and the impression surface left behind will be squeaky-clean (fig 1 and 2). A clean preparation will give you a more accurate impression; however, DETAIL does more than just clean the prep site. DETAIL also lowers the surface tension of the preparation so your impression material contacts the surface more intimately. The result? The most detailed and accurate impression possible.
MSDS Sheet Clinical Product Sheet Supplier Link 
"